The Queen Now Has A Crown!


Queens Wreath from 2015

Our Queen’s Wreath – 2015

Readers of JBRish who have been following along for a while might have read a bit about our Queen’s Wreath (Antigonon leptopus) vine (see links below). Up until recently, this plant has been a show stopper and then something happened…

The plant was just not filling out the way it did during the previous years. Instead of a full, swath of leaves and stems this what we saw.

 


Bare, sparse stems

A close up revealed how sparse the leaves where in relationship to the lush coat of heart-shaped leaves we anticipated.


closeup of sparse growth

It was only a vague shadow of its former glory and far from queen-like.


full side view - - sparse

Instead of the abundant bouquet of blooms in the first picture, this was the extent of the flowering.


single strand of paltry blooms

We examined the plant over time looking for insect damage, making sure the water was being amply applied and noting that we used the same fertilizing regimen of the past. At the base, the leaves were more lush so we looked more closely and then it hit us. Rabbits!


Rabbits were eating away at the base

Those pesky rabbits had decided that they now like the Queen’s Wreath and that it would become their salad bar. This was not an issue during the three or so seasons of beauty preceding this problem.

We knew what we had to do even though we didn’t relish the thought. Like other plants in our landscape, this would have to be rabbit-proofed. We erected a plastic barrier approximately thirty inches high.


a picture of the plastic fence

To completely thwart rabbits, some method needs to be used to keep them from digging under the barrier. Most of the time, having the “fencing” flat on the ground for several inches creating a lip and then topped with rocks will be discouraging enough. When done correctly, it forms a resistant border. (See yellow arrows below)


Fencing lip topped with rocks

We were sure to have the water supply located appropriately before fastening the barrier and now we had the fence around the entire plant. I wasn’t quite sure how to proceed. I knew I had to do something with the existing plant material. Some flowering vines (as well as other plants) will react negatively to a severe trim and the bloom may be lost for the current gardening year.

After all of this trouble, I didn’t want to risk that so I hedged my bet and severely trimmed one side while only moderately trimming the other side in hopes of preserving some of the flowers for this current season.

Luckily the plant began to flourish as in the past and now, at the end of the season, both sides have evened out and the plant is showing why it is called Queen’s Wreath.


Queen's Wreath glorious once again


Sprays of flowers cover the vine


Beautiful, blooming Queen's Wreath

You have to admit, although small, the plethora of blooms do put on a show.


Closeup of coral blooms

We are hopeful that this will be a long-lasting resolution to the Queen’s Wreath’s care and provide years of charming color!

 

 
Showy Queen’s Wreath – October, 2015

Reinforced Trellis Support – Reduce Metal Fatigue

 

Read more gardening posts HERE


**********


All original content on this blog is copyrighted by Jeffrey B. Ross with ALL Rights Reserved. While reference links back to JBRish.com are appreciated and encouraged, please acquire approval for any reproduction of original content from this website.

©Jeffrey B. Ross 2014 – 2018 – JBRish.com



Leave a Reply

Your email address will not be published. Required fields are marked *